Intel SBCEGBESW10 CLI manual Dot1x timeout tx-period, Timeout period is 30 seconds

802.1x Commands

The default value of this command should only be changed to adjust for unusual circumstances, such as unreliable links or specific behavioral problems with certain clients and authentication servers.

To provide a faster response time to the user, a smaller number than the default value should be entered.

Example

The following example sets the number of seconds that the device remains in the quiet state following a failed authentication exchange to 3600.

Console(config)# interface ethernet ext.16

Console(config-if)#dot1x timeout quiet-period 3600

dot1x timeout tx-period

The dot1x timeout tx-periodInterface Configuration mode command sets the number of seconds that the device waits for a response to an Extensible Authentication Protocol (EAP)-request/identity frame from the client before resending the request. To return to the default configuration, use the no form of this command.

Syntax

dot1x timeout tx-period seconds

no dot1x timeout tx-period

Parameters

•seconds — Specifies the time in seconds that the device waits for a response to an EAP-request/identity frame from the client before resending the request. (Range: 1- 65535 seconds)

Default Configuration

Timeout period is 30 seconds.

Command Mode

Interface Configuration (Ethernet) mode

Intel® Blade Server Ethernet Switch Modules SBCEGBESW1 and SBCEGBESW10 CLI Guide 389