Intel SBCEGBESW10 CLI Radius Commands, Radius-server host, No Radius server host is specified

19RADIUS Commands

radius-server host

The radius-server host Global Configuration mode command specifies a RADIUS server host. To delete the specified RADIUS host, use the no form of this command.

Syntax

radius-server host {ip-address hostname} [auth-portauth-port-number] [timeout timeout] [retransmit retries] [deadtime deadtime] [key key-string] [source source] [priority priority] [usage type]

no radius-server host {ip-addresshostname}

Parameters

•ip-address— IP address of the RADIUS server host.

•hostname — Hostname of the RADIUS server host. (Range: 1-158 characters)

•auth-port-number— Port number for authentication requests. The host is not used for authentication if the port number is set to 0. (Range: 0-65535)

•timeout — Specifies the timeout value in seconds. (Range: 1-30)

•retries — Specifies the retransmit value. (Range: 1-10)

•deadtime — Length of time in minutes during which a RADIUS server is skipped over by transaction requests. (Range: 0-2000)

•key-string— Specifies the authentication and encryption key for all RADIUS communications between the device and the RADIUS server. This key must match the encryption used on the RADIUS daemon. To specify an empty string, enter "". (Range: 0-128 characters)

•source — Specifies the source IP address to use for communication. 0.0.0.0 is interpreted as request to use the IP address of the outgoing IP interface.

•priority — Determines the order in which servers are used, where 0 has the highest priority. (Range: 0-65535)

•type — Specifies the usage type of the server. Possible values: login, dot.1x, wireless or all.

Default Configuration

No RADIUS server host is specified.

Intel® Blade Server Ethernet Switch Modules SBCEGBESW1 and SBCEGBESW10 CLI Guide 215