Procedures |
| Troubleshooting 5 |
|
|
|
Symptoms | Possible Causes | Possible Solutions | |
|
|
| |
SPARE LED on battery | Battery pack is defective. | If you have a battery pack in the | |
charger flashes red. |
| handset and one in the spare battery | |
|
| compartment, remove both battery | |
|
| packs from the charger to clear the | |
|
| red flashing LED. Then test each | |
|
| battery pack separately as follows: | |
|
| 1 Insert the battery pack in the | |
|
| handset and place the handset in | |
|
| the battery charger’s handset | |
|
| cradle. | |
|
| 2 Wait one minute. If the | |
|
| HANDSET LED flashes red, | |
|
| order a new battery pack. | |
| Contacts on the battery pack or in the | 1 Verify that there are no | |
| battery charger’s spare battery | obstructions on the battery pack | |
| compartment are dirty. | or battery charger contacts. | |
|
| 2 Unplug the charger and clean | |
|
| the contacts with a soft eraser. | |
|
| 3 Clean the battery pack contacts | |
|
| with a soft eraser. | |
| Battery pack is not seated properly in | Reseat the battery pack in the | |
| the spare battery compartment. | battery charger’s spare battery | |
|
| compartment, as described in | |
|
| Chapter 3. | |
|
|
| |
Handset is in the battery | Handset is not seated properly in the | Reseat the handset in the battery | |
charger cradle and the | battery charger cradle. | charger cradle. | |
HANDSET LED does | Battery power supply is not plugged | Check that the charger power cord | |
not light. | |||
in. | is plugged into the charger and into | ||
| |||
|
| an electrical outlet that is not | |
|
| controlled by a wall switch. | |
|
|
|
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use | Issue 3 October 1999 119 |
