Lucent Technologies MDW 9031DCP manual 117A4 117A3

Installing Multiple Carriers Installing the MDW 9031/9031DCP Pocket Phone 2

Installation Self-Test with a Single Radio Module in Each Carrier

To perform an installation self-test with a single radio module in each carrier:

1Wait a few seconds after powering up the carriers, then verify that the carriers’ OUT OF SYNC LEDs are not lit.

2The following illustration shows the correct LED lights for a five-carrier installation with one radio module installed in each carrier. This sample installation has four 117A4 carriers—one acting as the control carrier and the other three acting as expansion carriers—and one 117A3 carrier acting as an expansion carrier.

When correct installation procedures are followed and one radio module is present in each carrier, the red OUT OF SYNC LEDs will not be lit on any carrier, no matter which model. The other LEDs will be lit as follows:

~Model 117A4 control carrier CONTROL/EXPANSION LED = green

~Three Model 117A4 expansion carriers CONTROL/EXPANSION LED = amber

~The radio modules’ PASS and POWER LEDs = green

The Model 117A3 expansion carrier has no CONTROL/EXPANSION LED, but the DIP switch in Slot 4 of the carrier is set to Expansion.

ER

POWIO

RAD

PASS

OUT OF SYNC		OUT OF SYNC		OUT OF SYNC		OUT OF SYNC		OUT OF SYNC
CONTROL/	(green)	CONTROL/	(amber)	(DIP switch		CONTROL/	(amber)	CONTROL/	(amber)
EXPANSION		EXPANSION		in Slot 4 set to		EXPANSION		EXPANSION
	T T		T T	Expansion)	T T		T T		T T

CAUT ION CAUTION CAUTION CAUTION CAUTION

2 3 4 5 6 2 3 4 5 6 1 2 3 4 2 3 4 5 6 2 3 4 5 6

Control	Expansion	Expansion	Expansion	Expansion
Carrier	Carrier #1	Carrier #2	Carrier #3	Carrier #4
Model	Model	Model	Model	Model
117A4	117A4	117A3	117A4	117A4

MDW 9031/9031DCP Wireless Pocket Phone Installation and Use 503-801-166 Issue 3 October 1999 51