Lucent Technologies MDW 9031 manual Understanding Your Model 117A4 Carrier, Control/Expansion Led

Understanding Carriers Installing the MDW 9031/9031DCP Pocket Phone 2

Understanding Your Model 117A4 Carrier

The Model 117A4 carrier differs from the 117A3 in that it does not require that Slot 6 contain a radio module in order to pass the signal from the control carrier to the next carrier. It also does not have Power and Control/Expansion DIP switches to set. The 117A4 automatically adjusts its power level and senses whether it is being used as a control or an expansion carrier.

As the following illustration shows, the 117A4 does have an additional LED located on the right side of the carrier, the CONTROL/EXPANSION LED; this is used to determine whether the cabling was installed correctly.

Radio

TRANSTALK

Module

Mounting

Rods

Wall Mount

Hole

Label with Model Number (not shown)

Power Cord Connector (not shown)

Card Edge Connectors

Slot

Numbers

Wall Mount

Hole

Cable Manager Slot

1

2

3

4

5

6

			Radio
			Module
			Mounting
		RHAN	Rods
		-OK
	EAPT
MNNO		ERGR
	HAPT
	REPR	ACITE
		RU
	TFAM
	XER	IENLO
	KLAR
		M
	LORE	MIPSU	SYNC and CONTROL/EXP
	REPRAC
		ITE-OK
		RU	LED Codes Label
	TFAM
	LOREMIPSUM
	XER	IENLO
	KLAR
		-OK
	REPR	ACITE
		-OK
	REPR	ACITE
			Wall Mount
			Hole
			IN Jack
	UTION		OUT Jack
USEOANBLE
CA		LY
T&TC		7896
A	4766
P⁄N8		IN
		OUT	CONTROL/EXPANSION LED
OU	NTRON
		C
TOF		SYN
		L/
CO		SIO	(Model 117A4 Only)
EXPAN
			Slot
			Numbers
			Wall Mount
			Hole
			Rear
			Exit Slots

MDW 9031/9031DCP Wireless Pocket Phone Installation and Use 503-801-166 Issue 3 October 1999 27