Lucent Technologies MDW 9031DCP manual Test Modes, Using Local Test Mode

3 Using the MDW 9031/9031DCP Pocket Phone Handset

Test Modes

You can use Local Test Mode and Wireless Test Mode to verify that your handset is working properly and that the MDW 9031/9031DCP System is performing optimally.

Using Local Test Mode

You can use Local Test Mode to activate the audio warning signal, the vibrator, and all visual indicators on the handset display, enabling you to test the following:

•Does the audio warning signal work?

•Does the vibrator vibrate?

•Is the display operational?

•Are the visuals bright and clear?

Note: While in Local Test Mode, the MDW 9031/9031DCP cannot make or receive calls.

To use Local Test Mode:

1Make sure the handset is turned off.

2Press and hold the Select button ( ") for three seconds.

3While still holding ", press O.

The handset beeps twice, and the display shows the handset settings, indicating you are in Local Mode. (While in Local Mode, the MDW 9031/9031DCP can still receive notification of incoming calls.)

4Press #to enter Local Test Mode.

The handset emits two beeps, the vibrator vibrates, and all indicators on the display appear (including the rectangles and truncated triangles), as shown below.

Local Test Mode

MSG RANGE ON MUTE

If the beeps do not sound, the vibrator does not vibrate, or the indicators do not appear, repeat Steps 1–4. If you still have problems, call for customer support as described on the inside front cover of this book.

5To exit both Local Test Mode and Local Mode, press Oonce.

Note: You must exit Local Test Mode to reinstate proper call handling.

82 Issue 3 October 1999 MDW 9031/9031DCP Wireless Pocket Phone Installation and Use 503-801-166