3 Using the MDW 9031/9031DCP Pocket Phone | Handset | |
|
|
|
•Line Preselection
•Backlighting
•Alerter
Local Mode also gives you access to Local Test Mode (which enables you to test the alerter, vibrator, and display) and Wireless Test Mode (which enables you to test sound clarity, signal strength, and voice quality). While in Local Mode, the MDW 9031/9031DCP can still receive notification of incoming calls.
To access Local Mode, use the following procedure:
1Make sure the handset is turned off.
2Press and hold the Select button ( ") for three seconds.
3While still holding ", press O.
The handset beeps twice, and the display shows the handset settings. For example, the following display indicates that the handset:
~Is using button mapping for a PARTNER switch.
~Has the vibrator and Line Preselection enabled.
Changing the
Communications
System Button
Mapping Setting
~Has the alerter disabled.
4To exit Local Mode, press O.
If the MDW 9031/9031DCP Pocket Phone is set to use the wrong communications system, an error message saying CHANGE BUTTN MAP shows on the top line of the handset display each time the Obutton is pressed. If you see this message, use the procedure described in “Changing the Communications System Setting” in Chapter 2 to specify the correct communications system setting.
Enabling or Disabling the Vibrator
The vibrator vibrates to alert you to an incoming call in situations where you do not want to disturb others with an audible ring. You can enable or disable the vibrator using the following procedure:
1Make sure the handset is turned off.
2Press and hold the Select button ( ") for three seconds.
78 Issue 3 October 1999 | MDW 9031/9031DCP Wireless Pocket Phone Installation and Use |
