Lucent Technologies MDW 9031DCP manual Single Radio Module Installation Self-Test

2 Installing the MDW 9031/9031DCP Pocket Phone Installing a Single Radio Module

7Plug the power cord/AC adapter into a properly grounded, 3-prong wall outlet that is not controlled by an on/off switch.

!CAUTION:

Never connect or disconnect the telephone line cord while the radio module is plugged into the wall outlet.

Single Radio Module Installation Self-Test

Verify that the POWER and PASS LEDs on the radio module light. If the radio module’s PASS LED does not light:

1Unplug the power cord/AC adapter from the wall outlet.

2Wait 15 seconds.

3Plug it in again.

POWER

RADIO

PASS

Radio
ModuleER
W
PO	DIO
RA
PASS

4If the radio module’s PASS LED still does not light, refer to Chapter 5,

“Troubleshooting.”

20 Issue 3 October 1999 MDW 9031/9031DCP Wireless Pocket Phone Installation and Use 503-801-166