Lucent Technologies MDW 9031DCP manual AC Outlet Check

Models: MDW 9031 MDW 9031DCP

1 161
Download 161 pages 39.52 Kb
Page 19
Image 19

Important Safety Instructions

Installing the MDW 9031/9031DCP Pocket Phone 2

 

 

 

 

This product uses a 3-prong plug. Such plugs are designed for your safety. Do not attempt to defeat this purpose. If your wall outlet will not accept the plug, the outlet should be replaced by an electrician.

! WARNING:

Failure to properly ground this product will result in a risk of electrical shock, which can cause serious personal injury. This product requires a 3-prong AC outlet for safe operation. You should have your outlet checked by a qualified electrician (see “AC Outlet Check” below) before connecting this equipment.

AC Outlet Check

Have a qualified electrician check all of the outlets into which the MDW 9031/9031DCP radio modules or carriers, as well as the communications system switch/control unit, will be plugged. The electrician should check that the hot, neutral, and ground wires are properly connected to the outlet by using a circuit tester.

The outlet can also be tested using a voltmeter to take the measurements as shown:

120Volts

Neutral Phase

Less than

G

120

1 volt

 

volts

If the outlet does not meet the electrical specifications for grounded outlets, your MDW 9031/9031DCP Pocket Phone may not operate properly.

Note: If there is no current to the outlet or the voltages are not correct, the problem should be corrected by a qualified electrician.

Go to “Installation Overview for Radio Modules and Carriers.”

MDW 9031/9031DCP Wireless Pocket Phone Installation and Use 503-801-166

Issue 3 October 1999 11

Page 19
Image 19
Lucent Technologies MDW 9031DCP manual AC Outlet Check