Installing a Single Carrier | Installing the MDW 9031/9031DCP Pocket Phone 2 | ||
|
|
|
|
Installing a Single Carrier on a Shelf or Desk
•You will not receive optimum performance if the unit is placed on a desk or low shelf.
•Install the unit as high as possible, leaving 6 to 12 inches (15.2 to 30.5 cm) between the top of the antenna and the ceiling, if on a high shelf.
•Never install or remove a radio module from a carrier that is plugged into a wall outlet (hot insertion).
•See “Key Components” earlier in this chapter for additional picture detail.
To install a single carrier:
1Perform the tests described in “Using Wireless Test Mode” in Chapter 3 to determine the optimal placement of the radio module. To perform the tests, all you need is an electrical outlet for the radio module and a charged battery pack in the handset.
2Check to be sure the carrier’s power cord is unplugged from the wall outlet before continuing.
3Remove the plastic cap covering each radio module’s card edge before installing the radio modules in the carrier.
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use | Issue 3 October 1999 31 |
