Installing a Single Radio Module | Installing the MDW 9031/9031DCP Pocket Phone 2 | ||
|
|
|
|
Additional Rules for | • Install carrier(s) within 15 feet (5 m) of either side of, and within 6 to 8 feet (1.8 | |
Installing One or More | to 2.4 m) above, a properly grounded, | |
Carriers | ||
controlled by an on/off switch. | ||
| ||
| • Choose a location where handset users will not approach the carrier(s) | |
| within a radius of 6 feet (1.8 m) for 1 or 2 carriers or 10 feet (3 m) for 3 | |
| carriers. | |
| • When installing multiple carriers: | |
| ~ Install multiple carriers 1 foot (0.3 m) optimally to 4 feet (1.2 m) apart. | |
| ~ Install multiple carriers on the same horizontal axis (do not install one carrier | |
| higher or lower than another). | |
| ~ Install the control carrier as the leftmost carrier, using only the expansion | |
| cables provided. | |
| ~ Slot 6 of an 117A3 control carrier must always contain a radio module to pass | |
| the synchronization signal to the next carrier. |
! CAUTION:
Carrier(s) cannot be installed outdoors.
Go to “Using Wireless Test Mode” in Chapter 3.
Installing a Single Radio Module
•Install a single radio module high on a wall, leaving 6 to 12 inches (15.2 to 30.5 cm) between the top of the antenna and the ceiling.
•See “Key Components” earlier in this chapter for additional picture detail.
To install a single radio module:
1Perform the tests described in “Using Wireless Test Mode” in Chapter 3 to determine the optimal placement of the radio module. To perform the tests, all you need is an electrical outlet for the radio module and a charged battery pack in the handset.
2Check to be sure the radio module’s power cord is unplugged from the wall outlet before continuing.
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use | Issue 3 October 1999 17 |
