Installing Multiple Carriers | Installing the MDW 9031/9031DCP Pocket Phone 2 | ||
|
|
|
|
3If an OUT OF SYNC LED is lit, power down, wait at least 15 seconds, and then repower the carriers in order from left to right, as described in Step 9 in “Installing the Remaining Radio Modules.” If the LED is still lit, follow the suggestions in the “Installation Problems” section of Chapter 5, “Troubleshooting.” If the LED is still lit, call Customer Support as described in the Copyright and Legal Notices at the beginning of this book.
| OF | SYNC |
| OUT |
|
| CONTROL/ | |
4 | EXPANSION | |
|
4The PASS and POWER LEDs on all radio modules should be lit and green, indicating that all of the radio modules are functional. If a radio module’s PASS LED is not lit:
a Power down the carriers.
b From the wall outlet, unplug the power cord/AC adapter of the radio module that did not light.
c Wait 15 seconds.
d Plug in the radio module’s power cord again.
e Repower the carriers, following the proper
If the PASS LED is still not lit, follow the suggestions in the “Installation Problems” section of Chapter 5, “Troubleshooting.” If the LED is still not lit, call Customer Support as described in the Copyright and Legal Notices at the beginning of this book.
POWER
RADIO
PASS
Radio | ||
ModuleER | ||
W | ||
PO | DIO | |
RA | ||
| ||
PASS |
5Go to “ Handset” (page 60) .
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use | Issue 3 October 1999 59 |