Lucent Technologies MDW 9031DCP manual Enabling or Disabling the Alerter

Models: MDW 9031 MDW 9031DCP

1 161
Download 161 pages 39.52 Kb
Page 89
Image 89

Handset

Using the MDW 9031/9031DCP Pocket Phone 3

 

 

 

Enabling or Disabling the Alerter

The alerter is an audible signal to notify you of an incoming call. If a call comes in while the phone is idle, the handset rings. If you are already on a call, the handset chirps softly. You can adjust the volume of the alerter by pressing the “ +” button or the “ - button on the side of the handset when the phone is turned off. You can enable or disable the alerter using the following procedure:

1Make sure the handset is turned off.

2Press and hold the Select button ( ") for three seconds.

3While still holding ", press O.

The handset beeps twice, and the display shows the handset settings, indicating you are in Local Mode. (While in Local Mode, the MDW 9031/9031DCP can still receive notification of incoming calls.)

If the alerter is disabled, the No Ring icon (a bell with a line through it) appears in the second line of the display. For example:

ON

If the alerter is enabled, the icon is not displayed. For example:

ON

4Press “A” ( 2) on the dialpad to enable or disable the alerter.

5Press Oto exit Local Mode.

Note: Both the alerter and the vibrator can be disabled at the same time. In this case the only notification you have of an incoming call is that a line status indicator (a truncated triangle or a rectangle, depending on your communications system) flashes in the display.

MDW 9031/9031DCP Wireless Pocket Phone Installation and Use 503-801-166

Issue 3 October 1999 81

Page 89
Image 89
Lucent Technologies MDW 9031DCP manual Enabling or Disabling the Alerter