Installing Multiple Carriers | Installing the MDW 9031/9031DCP Pocket Phone 2 | ||
|
|
|
|
5The PASS and POWER LEDs on all radio modules should be lit and green. If a radio module’s PASS LED is not lit:
a Power down the carriers.
b From the wall outlet, unplug the power cord/AC adapter of the radio module that did not light.
c Wait 15 seconds.
d Plug in the radio module’s power cord again.
e Repower the carriers, following the proper
If the PASS LED is still not lit, follow the suggestions in the “Installation Problems” section of Chapter 5, “Troubleshooting.” If the LED is still not lit, call Customer Support as described in the Copyright and Legal Notices at the beginning of this book.
POWER
RADIO
PASS
Radio |
| |
ModuleER | ||
W | ||
PO | IO | |
RAD | ||
| ||
PASS | ||
6Verify that LEDs match the pattern in the illustration in Step 2; if so, you can feel confident that the carriers are cabled correctly and that the installed radio modules are all functional.
7Go to “ Installing the Remaining Radio Modules” (page 54) .
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use | Issue 3 October 1999 53 |
