Handset | Using the MDW 9031/9031DCP Pocket Phone 3 | |
|
|
|
Using Wireless Test Mode
You can determine sound clarity, signal strength, and voice quality using Wireless Test Mode.
You should use Wireless Test Mode to help you locate the best place to install the radio module(s) to optimize the performance of your MDW 9031/9031DCP Pocket Phone. Repeat the tests several times, with the radio module positioned in a different location each time.
By performing the tests as you walk around the area in which the handset will be used, you can determine the handset’s range and the voice quality throughout the area of coverage. To perform the tests, all you need is an electrical outlet for the radio module and a charged battery pack in the handset. You can perform the tests multiple times and in any order; and you can exit at any time by pressing O.
Note: Ignore anything that displays if you press 4 while in Wireless Test Mode.
These displays are for Lucent Technologies technicians’ use only.
To use Wireless Test Mode:
1Make sure the handset is turned off.
2Press and hold the Select button ( ") for three seconds.
3While still holding ", press O.
The handset beeps twice, and the display shows the handset settings, indicating you are in Local Mode. (While in Local Mode, the MDW 9031/9031DCP can still receive notification of incoming calls.)
4Press “W” ( 9) to enter Wireless Test Mode.
WIRELESS TEST appears on the top line of the handset display.
ON
The handset beeps twice and, if the vibrator is enabled, it vibrates; then you hear a simulated dial tone. This dial tone continues until you exit Wireless Test Mode. While in this mode, the MDW 9031/9031DCP cannot make or receive calls.
5To identify the matching radio module for this handset, press 3.
The display indicates in which slot in the individual carrier (SLOT: n) the matching radio module is located, using a number ( n) from 1 to 6. A
ON
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use | Issue 3 October 1999 83 |
