2 Installing the MDW 9031/9031DCP Pocket Phone | Installing a Single Carrier | ||
|
|
|
|
Installing a Single Carrier on a Wall
•Install the unit high on a wall, leaving 6 to 12 inches (15.2 to 30.5 cm) between the top of the antenna and the ceiling.
•Never install or remove a radio module from a carrier that is plugged into a wall outlet (hot insertion).
•See “Key Components” earlier in this chapter for additional picture detail.
To
1Perform the tests described in “Using Wireless Test Mode” in Chapter 3 to determine the optimal placement of the radio module. To perform the tests, all you need is an electrical outlet for the radio module and a charged battery pack in the handset.
2Check to be sure the carrier’s power cord is unplugged from the wall outlet before continuing.
3Place the carrier against the wall. Choose a location backed by a wooden stud (if unavailable, use toggle bolts instead of the supplied wood screws). Hold the carrier straight; use a level if needed. Using a nail or pencil, mark screw locations through the four
Start the screws, leaving the screw heads protruding approximately ½ inch
(12 mm) from the wall. Place the carrier assembly over the screws, then slide it downward to lock it into place. Tighten the screws.
TRANSTALK
CAUTIO | N |
| |
| IN |
OUT | |
OUEXCTPOOANFNTSSRYIOONLNC/ |
1 | 2 | 3 | 4 | 5 | 6 |
36 Issue 3 October 1999 | MDW 9031/9031DCP Wireless Pocket Phone Installation and Use |