3 Using the MDW 9031/9031DCP Pocket Phone | Handset | |
|
|
|
!CAUTION:
Plug ONLY the Supra 9031 headset cord or the Radium headset cord into the headset adapter.
Note: Calls cannot be heard on the handset receiver when the headset is plugged in to the headset adapter. The handset microphone is also deactivated. The range of the handset is slightly diminished when you are using a headset. You may need to move closer to the radio module or move the radio module closer to you.
If desired, you can disconnect the headset from the handset without dropping the call, either by unplugging the headset adapter from the handset or by releasing the Quick Disconnect plug from the headset adapter cord. You can then use the handset as you normally would.
Using the Headset On/Off Button
Answering Calls with a Headset
The headset On/Off button near the antenna becomes active only when the headset is plugged into the headset connector. The headset On/Off button is identical in function to the Obutton near the dialpad.
When you receive a call, you will hear a ringing tone or feel a vibration coming from the handset (you will not hear a tone from the headset itself).
To answer a call:
1Press either the headset On/Off button near the antenna or the Obutton near the dialpad.
Placing Calls with a To place a call with a headset:
Headset
1Press the On/Off button near the antenna or the Obutton near the dialpad to access an available line.
The microphone and earpiece in the handset are disabled.
2Dial the call as you would on a wired system phone.
3Press either the On/Off button near the antenna or the Obutton near the dialpad to end the call.
90 Issue 3 October 1999 | MDW 9031/9031DCP Wireless Pocket Phone Installation and Use |
