214 | Panasonic DA-PC700 specs

15.2 When the Print Quality is Poor

Condition

Cause

Treatment

Nothing is printed.	Multiple sheets of paper are fed	Fan the paper and load it again.
	at once (double feeding).	Operating Instructions (For
		Operating Instructions (For
		Copier)

	The toner in the toner cartridge	Replace with a new toner
	has been used up.	cartridge.
		Operating Instructions (For
		Copier)

	The drum or toner cartridge is	Replace with a new drum or toner
	defective or damaged.	cartridge.
		Operating Instructions (For
		Copier)

	May be due to high voltage	Contact your local authorized
	problem.	Panasonic service representative.

	The paper has moisture.	Replace with new paper.
		Operating Instructions (For
		Copier)

Character void.	The paper used is not suitable.	Replace with suitable paper.
		Operating Instructions (For
		Copier)

	The drum or toner cartridge is not	Set the drum or toner cartridge
	properly set.	properly.
		Operating Instructions (For
		Copier)

214

Image 228

Panasonic DA-PC700 manual 214

Contents

DA-PC700 TRADEMARKS/COPYRIGHTS Preface Types of Manuals Manual bundled with the main unit i.e. the copierManuals bundled with the Printer/Scanner Unit Using These Operating Instructions OrganizationIii Using Internet Services Setting Print ModeConfiguring by the Tools Mode Screen Precautions and Limitations Conventions Icons used in this manualBold face All kinds of buttons e.g. Click OK Safety Notes Precaution for power and earth connection Table of Contents Chapter Installing/ Configuring the Printer Drivers Setup for the Direct Print UtilityViii Chapter Setup for TCP/IP Windows NT/Windows Setup for Windows NetworkingSetup for NetWare Chapter Using the Internet Printing Protocol Using Internet ServicesSetting Print Mode Chapter Printing Reports/Lists Configuring by the Tools Mode Screen Precautions and LimitationsChapter Troubleshooting Xii Appendix Overview of the Printer Parallel interface connector Ethernet interface connectorMain Components and Their Functions Back View Using the Touch Panel Display Overview of the Printer Getting Ready to Print Connect the cable and make the necessary set- tings When connecting to a network Special Features Printer Setting Printer Environment Network Printer Environments TCP/IP Direct Print Utility for Windows 95/98/Me TCP/IP for Windows NT 4.0/Windows AppleTalk for Macintosh NetWare Internet printing Token Ring Setting IP Address for Network Environment Flow of SettingSetting method Using Touch Panel Display for Setting Setting IP address/subnet mask/gateway addressProcedure Select Print/Scan Mode Settings Select Network Settings Select Specify Address Machine will be rebooted Touch Exit Tools Checking/Setting Dhcp Environment Setting Port Activating Port Select Print/Scan Mode Settings Select Port Settings Select Port Status and then touch Change SettingsSelect LPD Select Enable Select Save Select Close twice Other setting items Select Exit Tools Power Saver Using the Power Saver ModeAutomatic Power Saver Mode About the Attached CD-ROM This page is intentionally left blank Setup Connecting Interface Cables Parallel Setup EthernetEthernet interface supports the following types of cable Memory Allocation UsesSuggested Values Useful Operations Flow of Printing For Windows Basic Way of Printing Online HelpUseful Operations Check the contents and touch Exit Checking Job Status Cancelling Printing From Printer Cancelling Jobs in Process Cancelling Jobs in the Printer Forced Outputting Outputting Waiting Jobs Outputting in Emulation Mode Switching Printer to Offline Select Print Mode Printing vs Copying Scanning This page is intentionally left blank This page is intentionally left blank This page is intentionally left blank This page is intentionally left blank Installing Configuring Printer Drivers Installation/Configuration Methods Settings on the PrinterSelect Print/Scan Mode Setting About the Printer Drivers Installing/Uninstalling Printer Drivers Installing/Configuring the Printer DriversFor a Local Printer Installing/Uninstalling the Printer Drivers For Windows 95/98/Me For a Network Printer Click Add Network Port Uninstalling the Printer Drivers Installing/Uninstalling the Printer Drivers Configuring the Printer Drivers Accessing the Printer Properties Dialog BoxFor Windows 95/98/Me Accessing the printer properties dialog box For Windows NT 4.0/Windows Setting the Printer Properties Printer Paper Source OptionsPaper Output Options Error Report Job Owner SettingsAuto Configuration Restore Defaults Paper/Output Job Type Paper Size Paper Source Output Destination Paper sizes available for each paper source are as follows Copies default Image OrientationSided Print Custom Paper Size Collate Settings Output OptionsFinishing Apply one staple at the top-right corner of paper Apply two staples at the left edge of paperApply two staples at the right edge of paper Apply one staple at the bottom-left corner of paper Punch Position EMF Spooling for Windows NT 4.0/Windows 2000 default off First Sheet Graphics Mode GraphicsHalftone Image Enhancement default on All Texts to Black default offTrueType Mode Use Printer TrueType Fonts default on Halftone Color Adjustment for Windows NT 4.0/Windows OverlaysLoad Overlay Create Overlay Delete Overlay Delete AllQuery Page Overlay Selected Overlay status Layout Mode Multi-Upavailable when Multi-Upis selected for Layout ModeLayout No page border is drawn Booklet Creation Zoom available when Zoom is selected for Layout Mode Top Left Top Right Center default Bottom Left Bottom Right None default Poster available when Poster is selected for Layout ModeShadow Custom Procedure to create a watermark is as follows Procedure to edit a watermark is as followsProcedure to delete a watermark is as follows Watermarks To print a watermark, the options available include Background This page is intentionally left blank Setup for Direct Print Utility Using the Direct Print Utility System ConfigurationTarget Computers Windows 95/98/Me Target computers must meet all the following requirements Flow of Setup Setup for the Direct Print Utility Setup of the Printer When the LPD Port is Disabled Setup of the Printer Other Settings Installing the Direct Print Utility Overview Setting the TCP/IP Protocol Installation Procedure Procedure to install the Direct Print Utility is as follows Restart the system for the installation to complete Setting the Port Click the Details tab Click Add Port Port Name Enter a name for identifying the printerIP Address Status Indication Status Indication Uninstalling Uninstalling This page is intentionally left blank TCP/IP Setup for TCP/IP Windows NT/Windows Setup for the Printer Setting the LPD Port to EnableWindows NT/Windows Setup for TCP/IP 2000 Setup for the Printer Windows NT/Windows Setup for TCP/IP 2000 Select Exit Tools Other Settings Setup for Windows NT For Windows NT 4.0/Windows100 Setup for Windows Networking Introduction System Structure102 Setup Procedure 103 Setup for Windows NetworkingInstall the printer driver to the host computer Setting NetBEUI in Printer Activating Port and Setting Protocol104 105 Setup for Windows Networking Select SMB 106 107 Setup for Windows Networking Setting TCP/IP in Printer Defining IP Address108 109 Setup for Windows Networking Refer to 7.2.2 Other Settings 110 111 Setup for Windows Networking Changing Printer Workgroup NameThrough Windows Networking 112 Close message.txt Setting format of config.txt 113Activation of NetBEUI protocol On/Off 114 Activation of Dhcp On/Off Wins Dhcp Resolve 115 Setup for Windows Networking Example of config.txt Auto Driver Downloading Preparation for Auto Driver Downloading116 117 Setup for Windows Networking Auto Downloading of Printer Driver 118 119 Setup for Windows Networking 120 Setup for NetWare Using NetWare Target Computers122 Target computers must meet the following requirements Setup for NetWare 123 InterfacePrinter supports the following types of Ethernet interface Following frame types are supported Setup for NetWare 124 Setting the Port to Enable Setup for NetWare 125Activate the NetWare¨ port by the following procedure 126 Select NetWare Setup for NetWare 127 Printing the Printer Settings List 128 Setup for the Client Setup for NetWare 129Windows 95/98/Me, Windows NT 4.0 or Windows This page is intentionally left blank Using Internet Printing Protocol System Environment 132Essential system environment is as follows Using the Internet Printing Protocol 133 Define the IP address 134 IPP DNS Setup of the Printer Installing the Printer Driver Using the Internet Printing Protocol 135 136 Using the Internet Printing Protocol 137 Click Have DiskManufacturers files from, and then click OK Screen to select the printer driver appears 138 Using Internet Services Using Internet Services Structure of the Internet Services Screen140 Using Internet Services 141 Target Host Computers and BrowsersHost computers Browsers Configuring Browser Checking Browsers142 For Netscape Communicator Using Internet Services 143 Proxy server settingPort number setting Checking Proxy Server and Port Number Configuring Printer Activating Internet Service144 Using Internet Services Select Port Settings Select Internet ServiceWith Port Status selected, touch Change Settings Select Enable and then touch Save Other Internet Service Settings Items 146Select Close twice until the screen at is displayed Using Internet Services 147 Activating BrowserActivating Browser Screen of the Internet Services is displayed Help148 Setting Print Mode Print Mode Operation 150 PCL 6 Settings List of PCL 6 Settings ItemsSetting Print Mode 151 Menu Item Description 152 Setting Print Mode 153 154 ISO-6 ISO 6 Ascii Setting Print Mode 155 Spaced font is selected Setting Procedure Select Print Mode from the menu screenTouch PCL6 Settings 156 Setting Print Mode 157 This page is intentionally left blank Printing Reports/Lists Types of Reports/Lists Types and Paper Sizes160 Types Printer Settings List About Printer Settings ListPrinting Reports/Lists 161 Printing result 162 Job History Report Printing Reports/Lists 163About Job History Report 164 ERR Printing Reports/Lists 165 Error History Report About Error History ReportPrints information related to printer errors 166 Printing Reports/Lists 167 PCL Settings List About PCL SettingsPrints the PCL settings of the printer 168 Printing Reports/Lists 169 PCL Fonts List 170About PCL Fonts List Printing Reports/Lists 171 PostScript Fonts List 172About PostScript Fonts List Printing Reports/Lists 173 Print Meter Report 174About Print Meter Report Printing Reports/Lists 175 PostScript Settings List About PostScript Settings List176 Printing Reports/Lists 177 Stored Print Job List 178About Stored Print Job List Following items will be included in the list Mailbox Size Printing Reports/Lists 179 How to Print Report/List 180Select Print Report/List Configuring By the Tools Mode Screen Tools Mode Displaying the Tools Mode Screen182 Exiting the Tools Mode Screen Configuring by the Tools Mode ScreenSelect Exit Tools on the Tools Mode screen 183 System/Meter Settings Common Settings184 Configuring by the Tools Mode Screen 185 Copy Mode Settings 186 Print/Scan Mode Settings Configuring by the Tools Mode Screen 187 188 Input no more than 12 characters from A-Z, 0-9 and space Configuring by the Tools Mode Screen 189 190 SMB Configuring by the Tools Mode Screen 191 Connected to any other salutation protocol 192 IPP Configuring by the Tools Mode Screen 193 194 Configuring by the Tools Mode Screen 195 Select Enable Select Save 196 Precautions Limitations When switching on/off power When cancelling printingWhen initialized hard disk General Precautions and Limitations 199 When using the finisher with the puncher attached On Using NetWare Setting Printer200 Setting Server Precautions and Limitations 201For NDS For Bindery Using Token Ring Interface Port During PrintingOthers 202 On Using TCP/IP LPD During SetupDuring Switching Power On/Off Precautions and Limitations 203 When LPD Spool is set to Off non-spool mode When LPD Spool is set to Hard Disk or Memory spool modeWhen the IP address or computer name is changed Take note of the following when printing On Using SMB Precautions and Limitations205 When SMB Spool is set to Hard Disk or Memory spool mode When printer is in offline mode206 Deleting jobs Troubleshooting When Problems Occur Exit the Tools Mode screen208 Condition Cause Treatment Troubleshooting 209 210 Raster for Graphics Mode. OrStop Troubleshooting 211 Tray will result in paperJam. Or the message Put XX-sized paper is Displayed When the Print Quality is Poor 212 Troubleshooting 213 Paper used is not suitable Replace with suitable paper 214 Troubleshooting 215 Paper has moisture Replace with new paper Unable to print Network Error 216 Troubleshooting 217 Following port . Click Spool Settings to display its Printer is not Printing 218Cause Verification Action Troubleshooting 219 220 Set NCP Packet Signature Option=X X 0, 1 or When Switch Off the Power Appears Troubleshooting 221Unable to Obtain Desired Print Results No Notification 222 Using TCP/IP When Using Windows 95/98/MeTroubleshooting 223 When Using Windows NT When the printer is not printing224 Unable to obtain the desired print results Using SMB Troubleshooting 225Printer is not Found Cannot Print Cannot Delete Documents from the Printer Window226 Troubleshooting 227 Cannot Perform Auto Driver Downloading 228 Appendix Main Specifications Specifications of the Printer230 Printing Area Appendix 231 Connectors and Allocation Signal Shape of the connector232 Pin arrangement Meaning of the signals All connections adhere to the Ieee 1284 connector standardAppendix 233 Using Overlays Printing Data CombinedCreating an Overlay 234 Printing with an Overlay Appendix 235Next, print your data with the overlay Printing Secured Print Sample Set Jobs236 Secured Print Storing Secured Print/Sample Set Jobs Appendix 237 Printing Secured Print/Sample Set Jobs 238 Appendix 239 240 Following screen appears For Secured Print job Glossary Glossary241 242 Symbol IndexIndex 243 244 Index 245 This page is intentionally left blank Memo Warranty