Panasonic DA-PC700 manual Configuring by the Tools Mode Screen 193

13.2 System/Meter Settings

Menu Item				Description
Memory Changes		(2) Memory (spool mode):
(con't...)		There is a receive buffer for spooling.
		Available memory capacity: 0.50 MB - 32.00 MB in increments of 0.25 MB (0.50
		MB*).
		The maximum memory capacity may change according to the free memory
		space.
		(3) Hard Disk* (spool mode)
		There is a receive buffer for spooling.
	¥	IPP Spool
		Sets the memory capacity of the IPP Spool.
		There are two parts of the IPP Spool:
		(1) Off (non-spool mode)
		Available memory capacity: 64 KB - 1024 KB in increments of 32 KB (256 KB*).
		(2) Hard Disk* (spool mode)
		There is a receive buffer for spooling.
	¥	PCL Memory
		Sets the memory capacity for the use of PCL 6. The printing speed may be
		increased when the memory capacity is increased. When printing documents
		with large amounts of data, the resolution might decrease. Increasing the
		memory capacity might prevent a decrease of resolution.
		Available memory capacity: 2.50-32.00 MB in increments of 0.25 MB (5.0 MB*).
			• When the Port Status of the port is set to Disable, the item
				corresponding to the port will not be selectable.
			•	Depending on the data volume sent from the computer, the releasing
				time for the computer may not be changed even if the memory
				capacity is increased.
			•	After removing the RAM module and switching on the power, the
				following process will be executed automatically if memory becomes
				insufficient compared with the previous memory setting:
				(1) Change and allocate the setting values of the various memories
				(e.g. Receive buffer memory).
				(2) If allocation in (1) is not possible, set the status of port related to
				Ethernet to Disable and reallocate.
			• When increasing the memory capacity of the receive buffer, either
				disable the port status of the port not in use or install the RAM
				module.
			•	Error code (086-701 or 086-705) may be displayed after memory
				changes. Simply press the Job Status Stop button on the control
				panel and you can continue using the machine.
			• All data stored in each of the memory capacity will be cleared if
				system is reset.
				* factory setting

13

Configuring by the Tools Mode Screen

193