Teledyne M300EM operation manual Manual Calibration With Zero/Span Valves

Teledyne API – Technical Manual - Model 300E Family CO Analyzers Calibration Procedures

9.3.MANUAL CALIBRATION WITH ZERO/SPAN VALVES

There are a variety of valve options available on the M300E/EM for handling calibration gases (see Section 5.6 for descriptions of each).

Generally performing calibration checks and zero/span point calibrations on analyzers with these options installed is similar to the methods discussed in the previous sections of this section. The primary differences are:

∙On instruments with Z/S valve options, zero air and span gas is supplied to the analyzer through other gas inlets besides the sample gas inlet.

∙The zero and span calibration operations are initiated directly and independently with dedicated keys (CALZ & CALS).

9.3.1.SETUP FOR CALIBRATION USING VALVE OPTIONS

Each of the various calibration valve options requires a different pneumatic setup that is dependent on the exact nature and number of valves present.

Figure 9-3: Pneumatic Connections – Option 50A: Zero/Span Calibration Valves

Figure 9-4: Pneumatic Connections – Option 50B: Zero/Pressurized Span Calibration Valves

04288D DCN5752 193