Teledyne M300EM Setup Variable, Numeric, Default, Value, Units, Range, Description, A-11

Teledyne API - T300/T300M and M300E/EM PN 04906H (DCN5840) APPENDIX A-2: Setup Variables For Serial I/O

Setup Variable	Numeric	Default	Value
	Units	Value	Range
ET_TARGET_DET	mV	4375	0–5000
ET_TARGET_CONC	PPM	40,	1–9999.99
		400 3, 8
ET_CONC_RANGE	Conc.	50,	0.1–50000
		5000 3, 8
STD_TEMP	ºK	321	1–500
STD_PRESS	"Hg	28.5,	1–50
		28.7 8,
		28.8 12, 18,
		28.1 4
BENCH_SET	ºC	48	0–100
		Warnings:
		43–53
WHEEL_SET	ºC	68,	0–100
		62 19,23
		Warnings:
		63–73,
		57–67 19,23
O2_CELL_SET 14	ºC	50	30–70
		Warnings:
		45–55
STD_O2_CELL_TEMP 14	ºK	323	1–500
ZERO_APPLY_IN_CAL 5	—	ON	OFF, ON

ZERO_DWELL 3, 5, 8	Seconds,	7,	1–60,
	Minutes 5	3 5	1–30 5
ZERO_SAMPLES 3, 5, 8	Samples	15,	1–1000
		750 5,
		1000 19
ZERO_FILT_SIZE 3, 5, 8	Samples	5,	1–100
		1 5
ZERO_LIMIT 3, 5, 8	Ratio	1.2,	0–5
		1.15 3, 8,
		1 5
ZERO_CAL 3, 5, 8	Ratio	1.18	0.5–5

Description

Target detector reading during electrical test.

Target concentration during electrical test.

D/A concentration range during electrical test.

Standard temperature for temperature compensation.

Standard pressure for pressure compensation.

Optical bench temperature set point and warning limits.

Wheel temperature set point and warning limits.

O2 sensor cell temperature set point and warning limits.

Standard O2 cell temperature for temperature compensation.

ON applies auto-reference offset and dilution factor during zero/span calibration;

OFF disables both.

(Only applicable if ZERO_ENABLE is ON.)

Dwell time after closing or opening zero scrubber valve.

Number of zero samples to average.

Auto-zero offset moving average filter size.

Minimum auto-zero ratio allowed; must be greater than this value to be valid.

Calibrated auto-zero ratio.

A-11