Teledyne M300EM operation manual Table Of Contents, Table of Contents

Teledyne API –Operation Manual - Model 300E Family CO Analyzers	Table of Contents
TABLE OF CONTENTS
PART I – GENERAL INFORMATION	21
1. INTRODUCTION	23
1.1. M300E FAMILY Overview	23
1.2. Additional Documentation	24
1.2.1. Using This Manual	25
2. SPECIFICATIONS AND APPROVALS	27
2.1. Specifications	27
2.2. EPA Equivalency Designation	28
2.3. TUV DESIGNATION	29
2.4. CE Mark Compliance	29
2.4.1. Emissions Compliance	29
2.4.2. Safety Compliance	29
3. GETTING STARTED	31
3.1. M300E/EM Analyzer Layout	31
3.2. Unpacking the M300E/EM Analyzer	37
3.2.1. Ventilation Clearance	38
3.3. Electrical Connections	38
3.3.1. Power Connection	38
3.3.2. Analog Output Connections	39
3.3.3. Connecting the Status Outputs	39
3.3.4. Connecting the Control Inputs	41
3.3.5. Connecting the Serial Ports	42
3.3.6. Connecting to a LAN or the Internet	42
3.3.7. Connecting to a Multidrop Network	42
3.4. Pneumatic Connections	42
3.4.1. Calibration Gases	42
3.4.1.1. Zero Air	42
3.4.1.2. Span Gas	43
3.4.2. Pneumatic Connections to M300E/EM Basic Configuration	44
3.4.2.1. Sample Gas Source	45
3.4.2.2. Calibration Gas Sources	45
3.4.2.3. Input Gas Venting	46
3.4.2.4. Exhaust Outlet	46
3.5. Initial Operation	46
3.5.1. Startup	47
3.5.2. Warm Up	48
3.5.3. Warning Messages	48
3.5.4. Functional Check	50
3.6. Initial Calibration of the M300E/EM	51
3.6.1. Interferents for CO2 Measurements	51
3.6.2. Initial Calibration Procedure for M300E/EM Analyzers without Options	51
3.6.2.1. Verifying the M300E/EM Reporting Range Settings	52
3.6.2.2. Dilution Ratio Set Up	53
3.6.2.3. Set CO Span Gas Concentration	54
3.6.2.4. Zero/Span Calibration	55
3.6.3. O2 Sensor Calibration Procedure	56
3.6.4. CO2 Sensor Calibration Procedure	56
4. FREQUENTLY ASKED QUESTIONS	57
4.1. FAQ’s	57
4.2. Glossary	58
5. OPTIONAL HARDWARE AND SOFTWARE	61
5.1. External Pumps (OPTions 10A-10E, 11, 13)	61
5.2. Rack Mount Kits (OPT 20 to OPT 23)	61

04288D DCN5752 ix