Teledyne M300EM Setup Variable, Numeric, Default, Value, Units, Range, Description, A-15

Teledyne API - T300/T300M and M300E/EM PN 04906H (DCN5840) APPENDIX A-2: Setup Variables For Serial I/O

Setup Variable	Numeric	Default	Value
	Units	Value	Range
TEST_CHAN_ID	—	NONE 0	NONE,
			CO
			MEASURE,
			CO
			REFERENC
			E,
			VACUUM
			PRESSURE,
			SAMPLE
			PRESSURE,
			SAMPLE
			FLOW,
			SAMPLE
			TEMP,
			BENCH
			TEMP,
			WHEEL
			TEMP,
			O2 CELL
			TEMP 14,
			CHASSIS
			TEMP,
			PHT DRIVE,
			TEMP4 5
REMOTE_CAL_MODE	—	LOW 0	LOW,
			HIGH,
			CO2 10,
			O2 14
PASS_ENABLE	—	OFF	ON, OFF
STABIL_FREQ	Seconds	10	1–300
		120 19, 23
STABIL_SAMPLES	Samples	25	2–40
PHOTO_TEMP_SET	mV	2500	0–5000
		Warnings:
		250–4750
SAMP_PRESS_SET	In-Hg	29.92	0–100
		Warnings:
		15–32

Description

Diagnostic analog output ID.

CO range or other gas to calibrate during contact closure or Hessen calibration.

ON enables passwords; OFF disables them.

Stability measurement sampling frequency.

Number of samples in concentration stability reading.

Photometer temperature warning limits. Set point is not used.

Sample pressure warning limits. Set point is not used.

A-15