Teledyne M300EM Pneumatic Set Up OPT 50B, Sample Gas Source, Calibration Gas Sources Span Gas

Optional Hardware and Software Teledyne API – Technical Manual - Model 300E Family CO Analyzers

5.6.3.2.Pneumatic Set Up (OPT 50B)

See Figure 3-2for the location of gas inlets and outlets.

Figure 5-6: Pneumatic Connections – Option 50B: Zero/Pressurized Span Calibration Valves

SAMPLE GAS SOURCE:

Attach a sample inlet line to the sample inlet port. The SAMPLE input line should not be more than 2 meters long.

∙Maximum pressure of any gas at the sample inlet should not exceed 1.5 in-hg above ambient pressure and ideally should equal ambient atmospheric pressure.

∙In applications where the sample gas is received from a pressurized manifold, a vent must be placed on the sample gas before it enters the analyzer.

CALIBRATION GAS SOURCES:

SPAN GAS:

∙Attach a gas line from the pressurized source of calibration gas (e.g. a bottle of NIST-SRM gas) to the SPAN inlet at 30 psig.

ZERO AIR:

∙Zero air is supplied via a zero air generator such as a Teledyne API’s M701.

∙An adjustable valve is installed in the zero air supply line to regulate the gas flow.

INPUT GAS VENTING:

The zero air supply and sample gas line MUST be vented in order to ensure that the gases input do not exceed the maximum inlet pressure of the analyzer as well as to prevent back diffusion and pressure effects. These vents should be:

∙At least 0.2m long;

∙No more than 2m long and;

∙Vented outside the shelter or immediate area surrounding the instrument.

A similar vent line should be connected to the VENT SPAN outlet on the back of the analyzer.

EXHAUST OUTLET

Attach an exhaust line to the analyzer’s EXHAUST outlet fitting. The exhaust line should be:

∙PTEF tubing; minimum O.D ¼”;

∙A maximum of 10 meters long;

∙Vented outside the analyzer’s enclosure.

68 04288D DCN5752