Teledyne UNPACKING THE M300E/EM ANALYZER, General Safety Hazard, Electrical Shock Hazard

Teledyne API – Technical Manual - Model 300E Family CO Analyzers Getting Started

3.2.UNPACKING THE M300E/EM ANALYZER

CAUTION

GENERAL SAFETY HAZARD

To avoid personal injury, always use two persons to lift and carry the M300E/EM.

CAUTION

ELECTRICAL SHOCK HAZARD

Never disconnect PCAs, wiring harnesses or electronic subassemblies while under

power.

CAUTION – Avoid Warranty Invalidation

Printed circuit assemblies (PCAs) are sensitive to electro-static discharges too small to be felt by the human nervous system. Damage resulting from failure to use ESD protection when working with electronic assemblies will void the instrument warranty.

See A Primer on Electro-Static Discharge in this manual for more information on preventing ESD damage.

NOTE

It is recommended that you store shipping containers/materials for future use if/when the instrument should be returned to the factory for repair and/or calibration serivce. See Warranty section in this manual and shipping procedures on our Website at http://www.teledyne-api.com under Customer Support > Return Authorization.

1.Verify that there is no apparent external shipping damage. If damage has occurred, please advise the shipper first, then Teledyne API.

2.Included with your analyzer is a printed record (Final Test and Validation Data Sheet: M300E PN 04307; M300EM PN 04311) of the final performance characterization performed on your instrument at the factory. This record is an important quality assurance and calibration record for this instrument. It should be placed in the quality records file for this instrument.

3.Carefully remove the top cover of the analyzer and check for internal shipping damage by:

∙Removing the setscrew located in the top, center of the Front panel;

∙Removing the two flat head, Phillips screws on the sides of the instrument (one per side towards the rear);

∙Sliding the cover backwards until it clears the analyzer’s front bezel, and;

∙Lifting the cover straight up.

4.Inspect the interior of the instrument to make sure all circuit boards and other components are in good shape and properly seated.

5.Check the connectors of the various internal wiring harnesses and pneumatic hoses to make sure they are firmly and properly seated.

6.Verify that all of the optional hardware ordered with the unit has been installed. These are listed on the paperwork accompanying the analyzer.

04288D DCN5752 37