TL-WA7510N
5GHz 150Mbps Outdoor Wireless Access Point User Guide
¾RTS Threshold - Here you can specify the RTS (Request to Send) Threshold. If the packet is larger than the specified RTS Threshold size, the Device will send RTS frames to a particular receiving station and negotiate the sending of a data frame. The default value is 2346.
¾Fragmentation Threshold - This value is the maximum size determining whether packets will be fragmented. Setting the Fragmentation Threshold too low may result in poor network performance since excessive packets. 2346 is the default setting and is recommended.
¾DTIM Interval - This value determines the interval of the Delivery Traffic Indication Message (DTIM). You can specify the value between
¾Enable WMM - WMM function can guarantee the packets with
¾Enable Short GI - This function is recommended for it will increase the data capacity by reducing the guard interval time.
¾Enable AP Isolation - Isolate all connected wireless stations so that wireless stations cannot access each other through WLAN. This function will be disabled if WDS/Bridge is enabled.
)Note:
If you are not familiar with the setting items in this page, it's strongly recommended to keep the provided default values; otherwise, it may result in lower wireless network performance.
5.7.5 Antenna Alignment
)Note:
This function is not available in AP Router mode, but in both Standard AP mode and AP Client Router mode.
Choose menu “Wireless > Antenna Alignment”, and then you can know how remote the Device’s signal strength changes while changing the antenna's direction.
Figure 5-35 Antenna Alignment
109
