TP-Link manual TL-WA7510N 5GHz 150Mbps Outdoor Wireless Access Point User Guide

TL-WA7510N5GHz 150Mbps Outdoor Wireless Access Point User Guide

zChannel - The current wireless channel in use.

zMode - The current wireless mode which the Device works on.

zMax Tx Rate - The maximum tx rate.

zMAC Address - The physical address of the Device, as seen from the WLAN.

zClient Status - The status of client.

Init: Connection is down; Scan: Try to find the AP; Auth: Try to authenticate; ASSOC: Try

to associate; Run: Associated successfully.

¾WAN - The following parameters apply to the WAN ports of the Device. You can configure them in the Network -> WAN page.

zMAC Address- The physical address of the WAN port, as seen from the Internet.

zIP Address - The current WAN (Internet) IP Address. This field will be blank or 0.0.0.0 if the IP Address is assigned dynamically and there is no connection to Internet.

zSubnet Mask - The subnet mask associated with the WAN IP Address.

zDefault Gateway - The Gateway currently used by the Device is shown here. When you use Dynamic IP as the connection Internet type, the Renew button will be displayed here. Click the Renew button to obtain new IP parameters dynamically from the ISP. And if you have got an IP address, Release button will be displayed here. Click the Release button to release the IP address the Device has obtained from the ISP.

zDNS Server - The DNS (Domain Name System) Server IP addresses currently used by the Device. Multiple DNS IP settings are common. Usually, the first available DNS Server is used.

zOnline Time - The time that you are online. When you use PPPoE as WAN connection type, the online time is displayed here. Click the Connect or Disconnect button to connect to or disconnect from Internet.

¾Secondary Connection - Besides PPPoE, if you use an extra connection type to connect to a local area network provided by ISP, then parameters of this secondary connection will be shown in this area.

¾Traffic Statistics - The Device's traffic statistics.

zSent (Bytes) - Traffic that counted in bytes has been sent out from the WAN port.

zSent (Packets) - Traffic that counted in packets has been sent out from WAN port.

zReceived (Bytes) - Traffic that counted in bytes has been received from the WAN port.

zReceived (Packets) - Traffic that counted in packets has been received from the WAN port.

¾System Up Time - The length of the time since the Device was last powered on or reset.

Click the Refresh button to get the latest status and settings of the Device.

78