SYSTem:SETup
Command :SYStem:SETup <block_data>
The SYStem:SETup command configures the logic analyzer module as
defined by the block data sent by the controller. The length of the
configuration data block can be up to 350,784 bytes in the 1660A.
There are four data sections which are always returned. These are the
strings which would be included in the section header:
"CONFIG "
"DISPLAY1 "
"BIG_ATTRIB"
"RTC_INFO "
Additionally, the following sections may also be included, depending on
what’s available:
"SYMBOLS A "
"SYMBOLS B "
"INVASM A "
"INVASM B "
"COMPARE "
With the exception of the RTC_INFO section, the block data is not described.
However, the RTC_INFO section contains the real-time clock time of the
acquired data in the data block. This time information can be meaningful to
some measurements.
DATA and SETup Commands
SYSTem:SETup
26–15