Black Box KV162A manual Servswitch Multi, 2. The User-Controls Menu, A Scanning, B Menu Activation

SERVSWITCH™ MULTI

9.2.3THE USER/ADMINISTRATOR-CONTROLS MENU

You can access this menu (shown as the User-Controls Menu in Figure 9-2) by pressing the [Ctrl] key twice, then pressing [Alt] + [Tab]. (System administrators will have to press [Alt] + [Tab] twice, because they have to bypass the User-List Menu—see Section 9.2.2.) If you are logged in as a user, you will see this menu as the User- Controls Menu; it will have the four options “Scanning,” “Menu Activation,” “Switch Alt. User Module,” and “Control Alt. User Module” that are described in the following subsections. If you are logged on as the system administrator, you will see the expanded options of the Administrator-Controls Menu instead (see Section 9.4).

Figure 9-2. The User-Controls Menu.

9.2.3.A Scanning

To activate scanning through the User Control Menu (which you can also do through keyboard commands— see Section 8.6), first highlight the “Scanning” option. Then use the space bar to cycle through the available scanning options: “Off,” “By address,” and “By name.” Press [Enter] to select your desired choice.

9.2.3.B Menu Activation

To enable or disable the activation of the on-screen display system with any of the normal preprogrammed key sequences ([Ctrl] twice, [Alt] twice, or [Shift] twice), first highlight the “Menu Activation” option. Then press the space bar to toggle between “On” (activation enabled) and “Off” (activation disabled). Press [Enter] to select your desired choice. Be aware that if you disable normal menu activation, the only way to get back into the on-screen display system is to press the <CM> Command Mode hotkey sequence (see Sections 8.2.1 and 8.12) to bring up the Command-Line Entry Menu (see Section 9.2.4); from there pressing [Alt] + [Tab] will cycle through the other menu screens as normal.

104