Cisco Systems OL-7396-01 Immediately Synchronizing Route Processor Configurations , Immediately Synchronizing Route Processor Counters (Catalyst8540 MSR), Synchronizing the Configurations During Switchover (Catalyst 8540 MSR)

5-6
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter5 Configuring Redundancy
Synchronizing the Configurations (Catalyst 8540 MSR)
Immediately Synchronizing Route Processor Configurations
(Catalyst 8540 MSR)
To immediately synchronize the configurations used by the two route processors, use the following
privileged EXEC command on the primary route processor:
Example
In the following example, both the startup and running configurat ions are synchronized immediately:
Switch# redundancy manual-sync both
Immediately Synchronizing Route Processor Counters (Catalyst8540 MSR)
To immediately synchronize the VC, interface, and signaling counters between pr imary and secondary
route processors, use the following privileged EXEC command on the pri mary route processor:
Example
In the following example all VC, interface, and signaling counter values are s ynchronized from the
primary to secondary route processors:
Switch# redundancy manual-sync counters
Synchronizing the Configurations During Switchover (Catalyst 8540 MSR)
To synchronize the configurations used by the two route processors during a switchover, perform the
following steps on the primary route processor, beginning in global configuration mode:
Command Purpose
redundancy manual-sync {startup-config |
running-config | both}
Immediately synchronizes the configuration.
Command Purpose
redundancy manual-sync counters Immediately synchronizes the VC, interface, and
signaling counters between route processors.
Command Purpose
Step1 Switch(config)# redundancy
Switch(config-r)#
Enters redundancy configuration mode.
Step2 Switch(config-r)# main-cpu
Switch(config-r-mc)#
Enters main CPU configuration submode.
Step3 Switch(config-r-mc)# sync config {startup |
running | both}1
Synchronizes either or both configurations during
switchover or writing the files to NVRAM.