Cisco Systems OL-7396-01 Deleting and Disabling Point-to-Multipoint CES Soft PVC Connections

19-74
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter19 Configuring Circuit Emulation Services
Configuring Point-to-Multipoint CES SoftPVC Connec tions
Deleting and Disabling Point-to-Multipoint CES Soft PVC Connections
This section describes the process used to delete all or part of a CES point-to-multipoint soft PVC
connection. This section also describes how to either enable or disable a point-to-multipoi nt CES
softPVC connection.
Deleting Point-to-Multipoint CES Soft PVC
This section describes the process used to delete either the entire CES point-to-multipoint softPVC
connection or delete a specific leaf of the connection from the connection.
To remove the entire CES point-to-multipoint softPVC connection, perform the following steps,
beginning in global configuration mode:
To delete a specific leaf of the CES point-to-multipoint softPVC connection, perform the following
steps, beginning in global configuration mode:
Examples
The following example shows how to remove the entire point-to-multipoint CES soft PVC connection
configured on the CBR interface 4/0/0 for CES circuit 0:
Source(config)# interface cbr 4/0/0
Source(config)# no ces circuit 0
The following example shows how to remove only party leaf 1 on the CES soft PVC connection
configured on the point-to-multipoint CES PVC 0:
Source(config)# interface cbr 4/0/0
Source(config-if)# ces pvc 0 p2mp
Source(ces-p2mp)# no party leaf-reference 30
Command Purpose
Step1 Switch(config)# interface cbr card/subcard/port
Switch(config-if)#
Selects the CES interface to be configured.
Step2 Switch(config-if)# no ces pvc circuit-id p2mp Deletes the CES point-to-multipoint soft PVC.
Command Purpose
Step1 Switch(config)# interface cbr card/subcard/port
Switch(config-if)#
Selects the CES interface to be configured.
Step2 Switch(config-if)# ces pvc circuit-id p2mp
Switch(ces-p2mp)#
Specifies the CBR interface circuit identifier and
changes to CES point-to-multipoint
configuration mode.
Step3 Switch(ces-p2mp)# no party leaf-reference
ref-numb er
Deletes a specific CES point-to-multipoint leaf
using the reference number.