Cisco Systems OL-7396-01 Configuring ATM Accounting SNMP Traps

15-10
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter15 Configuring ATM Accounting, RMON, and SNMP
Configuring ATM Accounting
Configuring ATM Accounting SNMP Traps
You can configure SNMP traps to be generated when the ATM accounting file reaches a specified
threshold. You can use these traps to alert you when a file is full and needs to be downloaded.
Configuring ATM Accounting Trap Generation
To configure ATM accounting SNMP traps, use the following command in global configuration mode:
Example
The following example shows how to configure ATM accounting SNMP traps to be sent when the file
size reaches 85 percent full:
Switch(config)# atm accounting trap threshold 85
Displaying ATM Accounting Trap Threshold Configuration
To display the ATM accounting trap threshold configuration, use the following EXEC command:
Example
The following example shows the ATM accounting trap threshold configuration using the
show atm accounting command:
Switch# show atm accounting
ATM Accounting Info: AdminStatus - UP; OperStatus : UP
Trap Threshold - 90 percent (4500000 bytes)
Interfaces:
File Entry 1: Name acctng_file1
Descr: atm accounting data
Min-age (seconds): 3600
Failed_attempt : C0
Sizes: Active 69 bytes (#records 0); Ready 73 bytes (#records 0)
selection Entry -
Selection entry 1, subtree - 1.3.6.1.4.1.9.10.18.1.1
Selection entry 1, list - FF.FE.BF.FC
Selection entry 1, connType - F0.00
Active selection -
Selection entry 1, subtree - 1.3.6.1.4.1.9.10.18.1.1
Selection entry 1, list - FF.FE.BF.FC
Selection entry 1, connType - F0.00
<information deleted>
Command Purpose
atm accounting trap threshold
percent-value
Configures the ATM accounting file threshold
to generate an SNMP trap when it reaches a
percentage of the maximum size.
Command Purpose
show atm accounting Displays the ATM accounting trap
configuration.