Cisco Systems OL-7396-01 Displaying the Output Threshold Maximum Configuration (Catalyst 8510 MSR and LightStream 1010)

9-20
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter9 Configuring Resource Management
Configuring Physical Interfaces
Note These commands affect all connections, including those already established.
These commands are not applicable for subinterface level configurations. For other restri ctions, refer to
the ATMSwitch Rou ter Command Reference publication.
Examples
The following example shows how to configure the interface output threshold CBR discard threshold to
87 percent of maximum size:
Switch(config)# interface atm 3/0/0
Switch(config-if)# atm output-threshold cbr discard 87
The following example shows how to configure the interface output discard threshol d for CBR EFCI
threshold to 50 percent of maximum size:
Switch(config)# interface atm 3/0/0
Switch(config-if)# atm output-threshold cbr efci 50
Displaying the Output Threshold Maximum Configuration (Catalyst 8510 MSR and LightStream 1010)
To display the output threshold maximum size configuration, use the following user EXEC command:
Example
The following example shows the interface output threshold maximum size configuration with FC-PCQ
installed:
Switch> show atm interface resource atm 3/0/0
Resource Management configuration:
Output queues:
Max sizes(explicit cfg): 30000 cbr, none vbr-rt, none vbr-nrt, none abr-ubr
Max sizes(installed): 30208 cbr, 256 vbr-rt, 4096 vbr-nrt, 12032 abr-ubr
Efci threshold: 50% cbr, 25% vbr-rt, 25% vbr-nrt, 25% abr, 25% ubr
Discard threshold: 87% cbr, 87% vbr-rt, 87% vbr-nrt, 87% abr, 87% ubr
Abr-relative-rate threshold: 25% abr
Pacing: disabled 0 Kbps rate configured, 0 Kbps rate installed
Service Categories supported: cbr,vbr-rt,vbr-nrt,abr,ubr
Link Distance: 0 kilometers
Controlled Link sharing:
Max aggregate guaranteed services: none RX, none TX
Max bandwidth: none cbr RX, none cbr TX, none vbr RX, none vbr TX,
none abr RX, none abr TX, none ubr RX, none ubr TX
Min bandwidth: none cbr RX, none cbr TX, none vbr RX, none vbr TX,
none abr RX, none abr TX, none ubr RX, none ubr TX
Best effort connection limit: disabled 0 max connections
Max traffic parameters by service (rate in Kbps, tolerance in cell-times):
Peak-cell-rate RX: none cbr, none vbr, none abr, none ubr
Peak-cell-rate TX: none cbr, none vbr, none abr, none ubr
Sustained-cell-rate: none vbr RX, none vbr TX
Minimum-cell-rate RX: none abr, none ubr
Minimum-cell-rate TX: none abr, none ubr
CDVT RX: none cbr, none vbr, none abr, none ubr
Command Purpose
show atm interface resource atm
card/subcard/port
Displays the output threshold maximum size
configuration.