Cisco Systems OL-7396-01 ATM Signalling Diagnostics Configuration Mode, Controller Configuration Mode

2-15
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter2 Understanding the User Interface
Accessing Each Command Mode
To exit ATM E.164 translation table configuration mode and return to privileged EXEC mode, use the
end command or press Ctrl-Z:
Switch(config-atm-e164)# end
Switch#
For detailed information on configuring E.164 addresses, see the Configuring E.164 Addr esses section
in Chapter 17, “Configuring Signalling Features.”
ATM Signalling Diagnostics Configuration Mode
ATM signalling diagnostics configuration mode provides access to commands used to configure the
signalling diagnostics table.
To enter ATM signalling diagnostics configuration mode from global configuration mode, use the
atm signalling diagnostics command and specify an index for the filter table; the prompt changes to the
ATM switch router’s hostname followed by (cfg-atmsig-diag):
Switch(config)# atm signalling diagnostics 1
Switch(cfg-atmsig-diag)
To exit ATM signalling diagnostics configuration mode and return to global configuration mode, use the
exit command:
Switch(cfg-atmsig-diag)# exit
Switch(config)#
To exit ATM signalling diagnostics configuration mode and return to privileged EXEC mode, use the
end command or press Ctrl-Z:
Switch(cfg-atmsig-diag)# end
Switch#
For detailed information on configuring signalling diagnostics, see the Configuring Signalling
Diagnostics Tables section in Chapter17, “Configuring Signalling Features.”
Controller Configuration Mode
Controller configuration mode provides access to commands used to configure physical and logical
parameters of a channelized interface.
To enter ATM controller configuration mode from global configuration mode, use the controller
command with a channel type and interface:
Switch(config)# controller e1 1/0/0
Switch(config-controller)#
To exit ATM controller configuration mode and return to global configuration mode, use the exit
command:
Switch(config-controller)# exit
Switch(config)#
To exit ATM controller configuration mode and return to privileged EXEC mode, use the end command
or press Ctrl-Z:
Switch(config-controller)# end
Switch#
For detailed information on configuring channel groups on a Frame Relay/FUNI interface, see
Chapter 20, “Configuring Frame Relay to ATM Interworking Port Adapter Interfaces.”