2-3
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter2 Understanding the User Interface
Accessing Each Command Mode
Interface range
configuration
From global configuration
mode, specify a range of
interfaces to configure with an
interface range command.
Switch(config-if)# To exit to global
configuration mode, use the
exit command.
To exit directly to privileged
EXEC mode, use the end
command or press Ctrl-Z.
Subinterface
configuration
From interface configuration
mode, specify a subinterface
with an interface command.
Switch(config-subif)# To exit to global
configuration mode, use the
exit command.
To exit directly to privileged
EXEC mode, use the end
command or press Ctrl-Z.
Line configuration From global configuration
mode, specify a line with a
line command.
Switch(config-line)# To exit to global
configuration mode, use the
exit command.
To exit directly to privileged
EXEC mode, use the end
command or press Ctrl-Z.
Map-list configuration From global configuration
mode, define a map list with
the map-list command.
Switch(config-map-list)# To exit to global
configuration mode, use the
exit command.
To enter map-class
configuration mode, use the
map-class command.
To exit directly to privileged
EXEC mode, use the end
command or press Ctrl-Z.
Map-class configuration From glob al configuration
mode, configure a map class
with the map-class command.
Switch(config-map-class)# To exit to global
configuration mode, use the
exit command.
To enter map-list
configuration mode, use the
map-list command.
To exit directly to privileged
EXEC mode, use the end
command or press Ctrl-Z.
ATM router configuration From global configuration
mode, configure the PNNI
routing protocol with the
atm router pnni command.
Switch(config-atm-router)# To exit to global
configuration mode, use the
exit command.
To exit directly to privileged
EXEC mode use the end
command or press Ctrl-Z.
Table2-1 Summary of Command Modes (continued)
Command Mode Access Method Prompt Exit Method