19-25
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter19 Configuring Circuit Emulation Services
Configuring T1/E1 Structured (n x 64) Circuit Emulation Services
Phase 2—Configuring a Hard PVC
To configure a hard PVC, follow these steps:
Command Purpose
Step1 Switch# show ces status Displays information about the current CBR
interfaces.
Use this command to choose the source CBR
port.
Step2 Switch# show atm status Displays information about the current ATM
interfaces.
Use this command to choose the destination ATM
port.
Note The interface must be up.
Step3 Switch# configure terminal
Switch(config)#
At the privileged EXEC prompt, enters global
configuration mode.
Step4 Switch(config)# interface cbr card/subcard/port
Switch(config-if)#
Selects the physical interface to be configured.
Step5 Switch(config-if)# shutdown Disables the interface.
Step6 Switch(config-if)# ces aal1 service {structured |
unstructured}
Configures the CES interface AAL1 service type.
Step7 Switch(config-if)# ces circuit circuit-id
[timeslots number]
Configures the following CES connection
attributes for the circuit:
•Circuit id number.
–
For CES T1 structured service,
use 1 through 24.
–
For CES E1 structured service,
use 1 through 31.
Note The 0 circuit identifier is reserved for
unstructured service.
•Time slots for the circuit for structured
service only.
–
For CES T1, the range is 1 through 24.
•For CES E1, the range is 1 through 31.