S y s t e m B o a r d E x p a n s i o n C a r d C o m p o n e n t s

32-bit,

33 MHz

AGP connector

PCI connector 1

PCI connector 2

PCI connector 3

64-bit,

66 MHz

PCI connector 4

PCI connector 5

NOTE: Install only 66-MHz expansion cards in the 66-MHz slots. You can install 33-MHz cards in the 66-MHz slots. However, the entire bus, including the integrated SCSI controller, will operate at only 33 MHz.

Installing an Expansion Card

CAUTION: Before you perform this procedure, see "Safety First— For You and Your Computer."

NOTICE: Before disconnecting a device from the computer, wait 10 to 20 seconds after disconnecting the computer from its electrical outlet. Before removing a component from the system board, verify that the standby power light on the system board has turned off. To locate this light, see "System Board Components" or the interior service label.

1Turn off the computer and devices, disconnect them from their electrical outlets, and wait 10 to 20 seconds.

2Lay the computer on its right side.

3Open the computer cover.

4Press the lever on the expansion card retention arm and raise the retention arm (see the following figure).

Removing and Installing Parts

109

Page 109
Image 109
Dell 530 manual Installing an Expansion Card, bit 33 MHz AGP connector PCI connector 64-bit 66 MHz