w w w . d e l l . c o m s u p p o r t . d e l l . c o m

VRM

Removing a VRM

Installing a VRM

NOTICE: A VRM must be installed for each microprocessor installed. To locate the VRM and microprocessor sockets, see "System Board Components" or the interior service label.

Removing a VRM

CAUTION: Before you perform this procedure, see "Safety First— For You and Your Computer."

NOTICE: Before disconnecting a device from the computer, wait 10 to 20 seconds after disconnecting the computer from its electrical outlet. Before removing a component from the system board, verify that the standby power light on the system board has turned off. To locate this light, see "System Board Components" or the interior service label.

1Remove the airflow shroud.

2Press the securing clips at each end of the socket outward simultaneously until the module pops out slightly from the socket (see the following figure).

3Lift the module away from the socket.

124

Removing and Installing Parts

Page 124
Image 124
Dell 530 manual Removing a VRM Installing a VRM, Remove the airflow shroud, Removing and Installing Parts