78 Removing and Installing Parts
www.dell.com | support.dell.com
14 When the System Memory total is correct, exit system setup.
15 Run the Dell Diagnostics to verify that the memory modules are
operating properly.
Removing a Memory Module NOTICE: Before disconnecting a device from the computer, wait 10 to 20
seconds after disconnecting the computer from its electrical outlet. Before
removing a component from the system board, verify that the standby power
light on the system board has turned off. T o locate this light, see "System Board
Components" or the interior service label.
NOTICE: To avoid damage to the memory module, press the securing clips
with equal force applied at each end of the memory socket.
1Press the securing clips at each end of the memory socket outward
simultaneously until the module pops out slightly from the socket (see
the following figure).
NOTE: To access the securing clips on the system board memory sockets,
it may be necessary to remove the fan for microprocessor 0. For
instructions on removing and installing the processor fan, see the
Service
Manual
.
2Lift the module away from the socket.
Removing a Memory Module
securing clips (2)
memory socket