2. Select the Target Mapping tab. All targets are displayed.
Figure 38: Target Mapping tab
3.Target mappings are displayed by WWPN, WWNN, or D_ID. “PB”, indicates mapping from persistent binding, while “Auto”, indicates an automapped target. In the Display Mode section, choose the display mode you want to use.
4.Change Setting - Click to change the active bind type (the mode used to persistently bind target mappings), LUN automapping or LUN unmasking settings. Select the active bind type (WWPN, WWNN or D_ID), enable or disable LUN automapping and/or set enable or disable LUN unmasking.
To add a persistent binding:
1.In the Targets Table, click the target that you want to bind.
2.Click Add Binding. The Add Persistent Binding dialog box is displayed.
Figure 39: Add Persistent Binding dialog box
3. Select the bind type that you want to use (WWPN, WWNN or D_ID).
The HBAnyware Utility User Manual | Page 98 |
