Emulex 3.4 user manual Storport Miniport Driver Parameters

Table 1: Storport Miniport Driver Parameters (Continued)

Parameter	Definitions	Activation
		Requirement
CoalesceRspCnt=n	CoalesceRspCn specifies the number of response entries that trigger	Reset
	an Interrupt response.
	Value: 0 - 255 (decimal) or 0x1 - 0xFF (hex)
	Default = 8 (0x8)
DiscoveryDelay=n	DiscoveryDelay controls whether the driver waits for ‘n’ seconds to	Dynamic
	start port discovery after link up.
	If set to 0 = immediate discovery after link up.
	If set to 1 or 2 = the number of seconds to wait after link-up before
	starting port discovery.
	Value: 0 - 2 seconds (decimal)
	Default = 0.
EnableAck0=n	Set to 1 to force sequence rather than frame level acknowledgement	Reset
	for class 2 traffic over an exchange. This applies to FCP data
	exchanges on IREAD and IWRITE commands.
	Value: 0 - 1 (decimal)
	Default = 0
EnableAUTH	EnableAUTH enables fabric authentication. This feature requires the	Reboot
	authentication to be supported by the fabric. Authentication is enabled
	when this value is set to 1.
	Value: 0 - 1
	Default = 0
EnableFDMI=n	If set to 1, enables management server login on fabric discovery. This	Reset
	allows Fabric-Device Management Interface (FDMI) to operate on
	switches that have FDMI-capable firmware.
	If set to 2, FDMI operates and uses the host name feature of FDMI.
	Value: 0 -2 (decimal)
	Default = 0
EnableNPIV=n	If set to 1, enables N_Port_ID virtualization (NPIV). Requires NPIV	Reset
	supported firmware and HBA.
	Value: 0 -1
	Default = 0 (disabled)
	Note: To run the driver using NPIV or SLI-3 optimization, the firmware
	must be version 2.72a0 or later. If an earlier version is used, the driver
	will run in SLI-2 mode and will not support NPIV.
FrameSizeMSB=n	FrameSizeMSB controls the upper byte of receive FrameSize if	Reset
	issued in PLOGI. This allows the FrameSize to be constrained on
	256-byte increments from 256 (1) to 2048 (8).
	Value: 0 - 8
	Default = 0

The HBAnyware Utility User Manual Page 55