Emulex 3.4 user manual Emlxs.conf Parameters

Table 4: emlxs.conf Parameters (Continued)

Property	Default	Min	Max	Activation	Comments
Name
cr-count	1	1	255	Requires	This value specifies a count
				link reset.	of I/O completions after
					which an interrupt response
					is generated. This feature is
					disabled if cr-delay is set to
					0.
cr-delay	0	0	63	Requires	This value specifies a count
				link reset.	of milliseconds after which
					an interrupt response
					generated if cr-count has
					not been satisfied. This
					value is set to 0 to disable
					the Coalesce Response
					feature as default.
enable-auth	0	0	1	Requires	This driver property
				link reset.	specifies if the DH-CHAP is
					enabled or not. When set to
					1, DH-CHAP is enabled.
					When set to 0, DH-CHAP
					support is disabled.
link-speed	0	0=auto select		Requires	Sets link speed for
		1=1G		link reset.	initializing FC connection.
		2=2G
		4=4G
		8=8G
linkup-delay	10	0	60	Requires	Sets the linkup delay period
				HBA reset.	(seconds) after HBA
					initialization.
log-notices	0xFFFFFFFF	0x00000000	0xFFFFFFFF	Requires	Verbose mask for notice
				reboot.	messages to the messages
					file.
log-warnings	0xFFFFFFFF	0x00000000	0xFFFFFFFF	Requires	Verbose mask for warning
				reboot.	messages to the messages
					file
log-errors	0xFFFFFFFF	0x00000000	0xFFFFFFFF	Requires	Verbose mask for error
				reboot.	messages to the messages
					file
network-on	0	0	1	Requires	Enables/disables IP
				reboot.	networking support in the
					driver.
num-iocbs	1024	128	10240	Requires	This variable indicates the
				HBA reset.	number of Input/Output
					Control Block (IOCB)
					buffers to allocate.

The HBAnyware Utility User Manual Page 77