Extron electronic JMP 9600 manual Changing the Fuses, Replacing Fuses

Changing the Fuses

The JMP 9600 is equipped with field replaceable fuses to protect against overcurrent damage. If one of the two power circuits fails, replace the fuses as follows:

WARNING: Physically disconnect both power cables from the player before removing the fuse module.

CAUTION: This unit employs double pole/neutral fusing.

1.Unplug both power cords.

2.With a Tweeker or other small screwdriver, gently pry the cover away from the AC

Power Input switch for the power circuit that has failed (see A on figure 81).

NOTE: The cover does not separate from the power block but hangs in place.

				50/60HZ
			0.4	-1A,
				FUSES
		-240VAC,AH	240V
	100	F2
INPUT:	ONLY:
USE

1

				50/60HZ.
			0.4	-1A,
				FUSES
		-240VAC,AH	240V
	100	F2
INPUT:	ONLY:
USE

2a

			0			50/60HZ.	2b
						FUSES
				.4	-1A,
		-240VAC,AH	240V
	100	F2
INPUT:	ONLY:
USE

Figure 81. Replacing Fuses

				50/60HZ.
			0.4	-1A,
				FUSES
		-240VAC,AH	240V
	100	F2
INPUT:	ONLY:
USE

3

3.Gently pry the fuse module from the power block (Ç) and pull it from the enclosure (É).

4.Remove and replace both fuses on the fuse module.

CAUTION: Replace the fuses with F2 AH 240V fuses only.

5.Slide the fuse module into the power block and snap it into position (C).

6.Snap the cover back into place on the power block.

7.Restore power.

JMP 9600 Media Player • Mounting and Maintenance 103