EEROM

The EEROM stores important amplitude-related correction data. This includes data for mixer-bias DACs, and RF Gain DACs (flatness correction). The analyzer serial number, model number, and installed options are also stored in EEROM.

Firmware

The analyzer firmware reads the model number and installed options from the EEROM to determine how to respond to certain keystrokes.

Display ASM

Much of the miscellaneous digital control is performed by A2UlOO. UlOO functions as the display ASM (Algorithmic State Machine) and character ROM. It also converts the 16-bit CPU data bus to an 8-bit data bus for the rest of the analyzer.

Display/Power Supply Section

A6 Power Supply

The A6 Power Supply is a switching supply operating at 40 kHz for the low voltages and

30 kHz for the CRT supplies (cathode, filament, +llO Vdc, and post accelerator). A6Al High Voltage Module contains the high-voltage transformer and post-accelerator multiplier. Power is distributed through W8 to Al7 and through Wl to the rest of the assemblies. A6AlW2 supplies CRT cathode and filament voltages to the Al7 assembly.

The speed of the analyzer’s fan is variable. A thermistor on A6 senses the temperature and adjusts the fan speed accordingly. This allows the analyzer to run quietly in most room-temperature environments and faster (louder) only when necessary.

Al7 CRT Display Driver

The Line Generators on the A2 assembly drive the Al7 CRT Driver. The Al7 assembly contains X and Y Deflection Amplifiers, focus and intensity grid amplifiers, and miscellaneous CRT bias circuitry. The high voltage is supplied by A6Al High Voltage Module.

In fast-analog zero-span mode (sweep times 530 ms), the O-SPAN VIDEO signal from A3 and the sweep ramp from Al4 goes to the Al7 CRT Driver. The graticule and annotation is still digitally drawn.

General Troubleshooting 6-43