5. DC Log Amplifier Adjustments

A4 LOG Fidelity Adjustment

This adjustment consists of adjusting A4R531 until the error is adjusted to zero.

Procedure

1.Set the HP 8560A (LINE) switch to off. Remove the analyzer cover and place the analyzer in the service position as illustrated in Figure 2-6. See Figure 2-7 for adjustment location.

2.Connect the HP 3335 50 R output to the HP 8560A 50 R input. Set the HP 8560A (LINE) switch on.

3.Press [m), ICAL), IF ADJ OFF, ADJ CURR IF STATE

4.Set the HP 8560A controls as follows:

C E N T E R F R E Q . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..15MHz

SPAN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .O

RES BW . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 300 kHz

REF LVL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -1OdBm

5. Set up an HP 3335A as follows:

FREQUENCY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..15MHz AMPLITUDE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -1OdBm

6.Press (MKR), MARKER DELTA and decrease the source power to -26 dBm.

7.Calcuate the error. The error = Delta Marker reading + 16 ( in dB).

8.Set the source power to -10 dBm.

9.Adjust A4R531 ( see Figure 2-7) to read two times the error, press LCAL),

ADJ CURR IF STATE.

10.Repeat to check. Readjust as necessary to get error adjusted to zero.

2-32 Adjustment Procedures