HP FAX-700 manual Introduction, Programming the Program Keys on the HP FAX-950

Introduction

This chapter contains helpful information about using the HP FAX-700, FAX-750, FAX-900, and FAX-950. To covered are:

DAdvanced Configurations

DUsing Program Keys

DSending to Multiple Stations (Broadcasting)

DCustomizing Internal Operating Parameters

DFaxing Tips

Note	Telephone numbers must be pre-programmed into either one-touch or speed
	programming the program keys for any or all of the following functions. Se
	3-30 for instructions in setting up one-touch and speed dial numbers

Programming the Program Keys on the HP FAX-950

Note The HP FAX-750 does not have program keys.

The HP FAX-950 has four program keys, P1–P4, located on the bottom row of the one-touch keypad also be used to set the fax machine for deferred transmission, polling, deferred polling a

Each function can be programmed to any or all four of the program keys. Once set, these fun pressing the appropriate program key.

If you have not already programmed the fax machine program keys, or wish to change a p need to enter the appropriate information for each key.

The procedures for programming the four functions are similar. Deferred transmission and to load the document onto the automatic document feeder before programming the f functions require you to remove any documents from the automatic document feeder bef

Use the numeric keypad to enter the time using the 4-digit, 24-hour (0000-2400) clock format. (Exam 17:30.)

Enter the station numbers using one or more of the dialing methods. Speed dialing requires code(s). One-touch dialing requires pressing a one-touch number for each station. If you ha speed-dial or one-touch numbers on your fax machine, refer to the information on o programming in chapter 3.

While entering station numbers, if you wish to scroll through and review the entered stat and Stamp buttons.

To correct an error, use the Clear button to delete the station number, then enter the co

Enter the program name (up to 15 characters) using the character code entry information in the information for the FAX-950 is on page 2-33.

Optimization 4￿3