HP FAX-700 manual Silent DET. Delay

Table 5-7. HP FAX-900 and FAX-950 Function Parameters (Continued)

No.	Parameter		Selections		Function
65	SILENT DETECTION		1	= Off	Selects the silent detection function
	(On)		2	= On	(TAM I/F). Same function as fax pa-
					rameter No. 20
66	SILENT DET. DELAY		00 = 0 sec		Selects silent detection delay time
	(20 sec)		.		(TAM I/F)
			.
			99 = 99 sec
67	SILENT INT. TIME		00 = 0 ms		Selects silent detection integration
	(5000 ms)		.		time (TAM I/F). The time can be se-
			.		lected from 0 to 9900 ms in 100 ms
			99 = 99 00 ms		steps. For example a setting of 50
					would select 5000 ms
68	RING COUNT (TAM)	1 = 1 time			Selects ring detect count of 1 to 9
			.		times in one-step intervals on TAM
			.		I/F mode
			9	= 9 times
69	Not Used
70	LINE ERROR		1	= 128 lines	Selects the line disconnect condition
	(128)		2	= 256 lines	during reception. If the number of line
			3	= 512 lines	errors exceeds this setting, the ma-
			4	= 1024 lines	chine will disconnect the line.
			5	= 2048 lines	Selects the transmit condition of RTP/
			6	= Off (will not disconnect thePIP or RTN/PIN if function parameter
			line)		73, ERROR DETECT, is set to
					“LINES”
71	TOTAL ERROR		1	= 5%	Selects transmit condition of RTP/PIP
	(10%)		2	= 10%	or RTN/PIN if function parameter 73,
			3	= 15%	ERROR DETECT, is set to “RATE”
			4	= 20%

72	CONTI. ERROR	1	= 3 lines/STD
	(Off)	2	= 6 lines/STD
		3	= 12 lines/STD
		4	= Off
73	ERROR DETECT	1	= Lines
	(Rate)	2	= Rate
74	RTN RECEIVE	1	= Disconnect
	(Discon)	2	= Continue
75	MH/MR/MMR	1 = MH (MH only)
		2	= MR (MH or MR)
		3	= MMR (MH or MR or MMR)
76-79	Not Used
80	DOC TOP FEED	00 = 0 mm
	(15 mm)	.
		.
		99 = 99 mm

Selects continuous total error criter for Standard Mode. If continuous total err exceeds this setting, the unit will transmit RTN/PIN. Available if func-

tion parameter 73, ERROR DETECT, is set to “RATE”

Selects error detect condition

Selects the reaction of the fax ma- chine when RTN is received

Selects coding scheme

Adjusts distance between scanning sensor ON position and scanning start position

5￿40 Problem Resolution