HP FAX-700 manual Silent Detection

Table 4-3. HP FAX-950 Parameter Options (Continued)

2￿Digit	Parameter￿ Name
Parameter	Options￿ (choices)￿
Number	*￿ factory￿ set	Description
07	HEADER￿ PRINT	Specifies￿ location￿ of￿ headers￿ and￿ footers.
	1:￿ Inside￿ *	Header￿ and￿ footer￿ printed￿ inside￿ image￿ area.
	2:￿ Outside	Header￿ and￿ footer￿ printed￿ outside￿ image￿ area.
	3:￿ No￿ Print	Header￿ and￿ footer￿ not￿ printed.
08	HEADER￿ FORMAT	Specifies￿ header￿ content￿ of￿ outgoing￿ documents.
	1:￿ Logo￿ ID￿ No.￿ *	Your￿ logo￿ and￿ ID￿ appear￿ in￿ header.
	2:￿ From￿ To	Your￿ logo￿ and￿ receiving￿ station￿ name￿ in￿ header.
09	RCV'D￿ TIME￿ PRINT	Specifies￿ printing￿ of￿ receive￿ time￿ on￿ documents.
	1:￿ Invalid￿ *	No￿ receive￿ information￿ printed.
	2:￿ Valid	Received￿ Time,￿ Sender's￿ ID￿ &￿ page￿ numbers￿ printed.
10	KEY/BUZZER￿ VOLUME	Specifies￿ beep￿ volume￿ (loudness)￿ of￿ fax￿ machine.
	1:￿ Off	Beep￿ not￿ audible.
	2:￿ Soft￿ *	Low￿ (soft)￿ volume.
	3.￿ Loud	High￿ (loud)￿ volume.
12	COMM.￿ JOURNAL	Specifies￿ printing￿ of￿ communication￿ journal.
	1:￿ Off	Journal￿ not￿ printed.
	2:￿ Always	Journal￿ is￿ printed￿ after￿ every￿ fax￿ transmission.
	3:￿ ￿ Inc.￿ only￿ *	Journal￿ is￿ printed￿ only￿ when
		communication￿ fails.
13	AUTO￿ JRNL￿ PRINT	Specifies￿ communication￿ journal￿ printing.
	1:￿ Invalid	Does￿ not￿ print￿ journal￿ every￿ 32￿ transactions.
	2:￿ Valid￿ *	Automatically￿ printed￿ every￿ 32￿ transactions.
15	ATTENDED￿ MODE	Specifies￿ attended￿ reception￿ mode.
	1:￿ Tel￿ *	Normally￿ for￿ voice￿ calls,￿ requires￿ user￿ action￿ to￿ receive￿ a￿ fax￿ call.
	2:￿ Fax/Tel￿ Sw.	Normally￿ for￿ fax￿ calls,￿ requires￿ user￿ action￿ to￿ receive￿ voice￿ calls.
16	UNATTENDED￿ MODE	Specifies￿ unattended￿ reception￿ mode,￿ connection￿ of￿ answering
		machine.
	1:￿ Fax￿ *	Normally￿ receive￿ fax￿ only￿ calls,￿ an￿ answering￿ machine￿ not￿ conF
		nected.
	2:￿ Tam￿ I/F	Receive￿ voice￿ and￿ fax￿ calls,￿ an￿ answering￿ machine￿ is￿ connected.
18	OP￿ CALL￿ TIMER	Specifies￿ time￿ to￿ make￿ the￿ beep￿ after￿ detecting￿ a￿ call￿ when￿ fax￿ pa
	1.￿ 20￿ sec￿ *	rameter￿ 15￿ is￿ set￿ to￿ option￿ 2.￿ Used￿ to￿ specify￿ time￿ available￿ to￿ pi
	2.￿ 30￿ sec	up￿ a￿ phone￿ for￿ a￿ voice￿ call.
	3.￿ 40￿ sec
	4.￿ 50￿ sec
19	OGM￿ LENGTH	Specifies￿ length￿ of￿ time￿ allocated￿ for￿ Out￿ Going￿ Message￿ recorded
	__￿ __￿ ￿ ￿ (1￿ to￿ 60￿ sec)on￿ answering￿ machine.￿ OGM￿ length￿ should￿ be￿ set￿ to￿ match￿ the
	20￿ sec*	length￿ of￿ time￿ of￿ the￿ recorded￿ message￿ on￿ the￿ answering￿ machine.
		During￿ the￿ message,￿ the￿ fax￿ machine￿ monitors￿ the￿ incoming￿ line
		for￿ a￿ fax￿ tone.
20	SILENT￿ DETECTION	Specifies￿ reaction￿ to￿ undetected￿ fax￿ signal￿ (effective￿ when￿ ParameF
		ter￿ 16￿ set￿ to￿ option￿ 2).
	1:￿ Invalid	Set￿ if￿ answering￿ machine￿ uses￿ one￿ tape￿ for￿ both￿ incoming￿ and￿ outF
		going￿ messages.
	2:￿ Valid￿ *	Detects￿ fax￿ calls￿ even￿ if￿ fax￿ signal￿ is￿ not￿ sent.

4￿38 Optimization