Return to Section TOC

Section TOC

Return to Master TOC

Master TOC

A-4

INSTALLATION

A-4

SAFETY PRECAUTIONS

LIFTING

 

 

 

 

 

 

 

 

 

 

 

 

WARNING

 

Lift the machine by the lift bail only.

The lift bail is

 

 

 

 

 

 

designed to lift the power source only. Do not

 

 

 

ELECTRIC SHOCK

attempt to lift the Power Wave with accessories

 

 

 

 

 

 

attached to it.

 

 

 

 

can kill.

 

 

 

 

 

 

 

 

 

Only qualified personnel should per-

 

 

 

 

 

 

form this installation.

FEEDER AND CONTROL BOX

 

 

 

Turn off the input power to the power

MOUNTING

 

 

 

 

 

source at the disconnect switch or

 

 

 

 

 

 

fuse box before working on this equip-

SEPARATION FROM BENCH MODEL

 

 

 

 

ment. Turn off the input power to any

 

 

 

 

 

 

 

 

 

 

other equipment connected to the

The Control Box can be removed from the bench

 

 

 

 

welding system at the disconnect

 

 

 

 

model feeder and mounted in a different location.

 

 

 

 

switch or fuse box before working on

 

 

 

 

See Figure A-1.

 

 

 

 

 

this equipment.

 

 

 

 

 

 

 

 

 

 

Do not touch electrically hot parts.

FIGURE A.1 — SEPARATING CONTROL BOX

 

 

 

 

 

 

AND FEEDER.

 

Return to

Return to Section TOC

Always connect the Power Wave grounding lug (located inside the reconnect input access door) to a proper safety (Earth) ground.

-----------------------------------------------------------

LOCATION AND MOUNTING

Place the welder where clean cooling air can freely circulate in through the rear louvers and out through the case sides and bottom. Dirt, dust, or any foreign material that can be drawn into the welder should be kept at a minimum. Using filters on the air intake to prevent dirt from building up restricts air flow. Do not use such filters. Failure to observe these precau- tions can result in excessive operating temperatures and nuisance shutdowns.

WIRE

CONTROLDRIVE

BOX

CENTERCONNECTOR

PANEL

MOUNTING

SCREW

BOTTOM

PANEL

Complete the following steps to remove the Control Box:

STACKING

Power Wave machines can be stacked to a maxi- mum of three high. The bottom machine must always be placed on a firm, secure, level surface. There is a danger of machines toppling over if this precaution is not taken.

1.Remove the bottom and center option panels from the front of the Control Box.

2.Disconnect the connector between the Control Box and the wire drive located in the middle of the Control Box back near the bottom of the Control Box.

Return to Section TOC

Return to Master TOC

ENVIRONMENT

The Power Wave power source carries an IP21 envi- ronmental rating. If subjected to occasional falling water, such as rain, the machine should be sheltered.

POWER WAVE 455/POWER FEED 10

Page 10
Image 10
Lincoln Electric SVM135-B service manual Safety Precautions, Location and Mounting