Section TOC
Master TOC
TROUBLESHOOTING AND REPAIR |
GEAR BOX AND DRIVE MOTOR REMOVAL AND REPLACEMENT (continued)
FIGURE F.20 — GEAR BOX AND DRIVE MOTOR REMOVAL AND REPLACEMENT.
DRIVE
MOTOR
GEAR BOX
#551#550
(BLACK) (WHITE)
INSULATION
J4
MOUNTING BOLT
INSPECTION COVER
WIRE
DRIVE
ASSEMBLY
GAS
FITTING 
Return to Master TOC
PROCEDURE
1.Remove the input power to the wire drive unit.
2.Using the 3/8 in. nutdriver, remove the case cover.
3.Locate and remove plug J4 from the control board. Refer to Figure F.20.
4.Thread plug J4 and associated leads through the vertical baffle. Cut any necessary cable ties.
5.Locate and disconnect the motor leads (#551 and #550) at the quick connects. Cut any necessary cable ties.
6.Using the Phillips head screwdriver, remove the #67 lead from the conduc- tor block.
